Product Reference Guide
17
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are pres-
ent and undamaged. If any damage occurred during shipment, contact Dat-
alogic Technical Support. Information is shown on page 2.
KEEP THE PACKAGING. Should the unit ever require service, it should be
returned in its original shipping container.
Setting Up the Reader
Depending on whether you are using a Corded or BT version of the Gryphon,
f
ollow the steps provided in this section to connect and get your reader up
and communicating with its host.
1. Begin by Installing the Interface Cable (Corded) or Connecting the Base
Station (BT)
2. Go to Interface Selection and set the desired interface.
3. Configure Interface Settings (only if not using factory settings for that
interface)
4. Go to Configuring Other Features (if modifications are needed from
factory settings)
To Next Page
Loading...
Need help?
General
