Setup
18
Gryphon™ I GD44XX/GBT4400/GM440X
Installing the Interface Cable
For Corded versions, connect the reader cable by inserting the cable into the
handle as shown in Figure 2. To remove it, insert a paper clip into the
release aperture, then unplug the cable.
Figure 2. Connect/disconnect the cable
RS-232 Serial
Connection
Turn off power to the terminal/PC and connect the reader to the terminal/PC
serial port via the RS-232 cable as shown in Figure 3. If the terminal will not
support POT (Power Off the Terminal) to supply reader power, use the
approved power
supply (AC Adapter). Plug the AC Adapter barrel connector
into the socket on the RS-232 cable connector and the AC Adapter plug into
a standard power outlet.
Figure 3. RS-232 Connection
To Next Page
Loading...
Need help?
General
