EasyManua.ls Logo

Datalogic Gryphon I GM440 Series

Datalogic Gryphon I GM440 Series
350 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical Specifications
316
Gryphon™ I GD44XX/GBT4400/GM440X
LED and Beeper Indications
The reader’s beeper sounds and its LED illuminates to indicate various func-
tions or errors on the reader. An optional “Green Spot” also performs useful
f
unctions. The tables below list these indications. One exception to the
behaviors listed in the tables is that the reader’s functions are programma-
ble, and may or may not be turned on. For example, certain indications such
as the
power-up beep can be disabled using programming bar code labels.
Table 51.
INDICATION DESCRIPTION LED BEEPER
Power-up Beep
The reader is in the process
of poweri
ng-up.
Reader beeps four times at
hi
ghest frequency and vol-
ume upon power-up.
Good Read
Beep
A label has been successfully
s
canned by the reader.
LED behavior for this
ind
ication is configu-
rable via the feature
Good Read: When to
Indicate
The reader will beep once at
curr
ent frequency, volume,
mono/bi-tonal setting and
duration upon a successful
label scan.
ROM Failure
There is an error in the
r
eader's software/program-
ming
Flashes
Reader sounds one error
beep
at highest volume.
Limited Scan-
ning Label Read
Indicates that a host connec-
tion is not established when
the IB
M or USB interface is
enabled.
N/A
Reader 'chirps' six times at
t
he highest frequency and
current volume.
Reader Active
Mod
e
The reader is active and ready
to scan.
The LED is lit steadily
a
a. Except when in sleep mode or when a
Good Read LED Duration
other than 00 is selected
N/A
Reader
Disabled
The reader has been disabled
by the
host.
The LED blinks continu-
ously
N/A
Green Spot is
on continuously
While in Stand Mode or Trig-
ger Stand Mode the green
spot
shall be on while in
stand watch state.
N/A N/A
Green Spot
a
flashes
momentarily
Upon successful read of a
labe
l, the software shall turn
the green spot on for the
time specified by the config-
ured value.
N/A N/A
Image Capture When ready to capture image
Blue light flashes 2
tim
es when updating
N/A
LED and Beeper Indications

Table of Contents

Related product manuals