QR Code Enter/Exit Programming Mode
Product Reference Guide
237
QR Code
Set Length 1
Specifies one of the bar code lengths for QR Code Length Control. Length 1
is the minimum label length if in Variable Length Mode, or the first fixed
length if in Fixed L
ength Mode. Characters can be set from 0001 to 7,089
characters in increments of 0001 (pad with zeroes).
See page 283 for detailed instructions on setting this feature.
Select QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad r
epresenting
your desired character(s). End by scanning the
ENTE
R/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code t
o abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
0001 = Length 1 is 1 Character
To Next Page
Loading...
