Product Reference Guide
43
RS-232 INTERFACE
BAUD RATE on page 44
DATA BITS on page 45
STOP BITS on page 45
PARITY on page 46
HANDSHAKING CONTROL on page 47
Use the programming bar codes in this section if modifications to the
st
andard RS-232 interface settings are necessary to meet your system’s
requirements. Additional settings which apply to both the RS-232 and
USB interfaces are available in the next section, "RS-232/USB-Com
Interfaces" starting on page 48.
Reference Appendix B, Standard Defaults for a listing of standard fac-
tory settings.
To Next Page
Loading...
