Datalogic PowerScan PBT9500 User Manual

Product Reference Guide 7
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are pres-
ent and undamaged. If any damage occurred during shipment, contact Dat-
alogic Technical Support. Information is shown on
page 2.
KEEP THE PACKAGING. Should the unit ever require service, it should be
re
turned in its original shipping container.
Setting Up the Reader
Follow the steps below to connect and get your reader up and communicat-
ing with its host.
1. Begin by Installing the Interface Cable (Corded) or Connecting
the Base
Station (Bluetooth and STAR)
2. Configure Interface Settings (see
page 14).
3. Configure the Reader starting on
page 17 (optional, depends on set-
tings needed)
Connect the PowerScan by plugging directly into the host device as shown.
T
he power can also be supplied through an external power supply via the
Interface Cable supplied with a power jack.

Datalogic PowerScan PBT9500 Specifications

General

Type	Handheld bar code reader
Wavelength	680 nm
Sensor type	Laser
Scanner type	1D/2D
Tilt reading angle	0 - 360 °
Pitch reading angle	0 - 40 °
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	-
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, MaxiCode, Micro QR Code, QR Code
Battery life	10 h
Charging time	4 h
Battery capacity	2150 mAh
Power source type	Battery
Number of reads per charge	30000
Number of batteries supported	1
Wireless range	100 m
Operating frequency	2400 - 2480 MHz
Standard interfaces	USB, RS-232
Connectivity technology	Wired & Wireless
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Buzzer	Yes
Certification	IEC 62471 Class 1 LED
Product color	Black, Yellow
Protection features	Shock resistant, Water resistant
International Protection (IP) code	IP65
Cables included	RS-232

Weight and Dimensions

Depth	74 mm
Width	110 mm
Height	212 mm
Weight	380 g