Enter/Exit Programming Mode
80
PowerScan™ PD9530/PBT9500/PM9500
Multiple Labels Ordering by Code Symbology
This feature allows you to specify the order multiple labels are transmitted
by symbology type, when Multiple Labels per Frame is enabled. See
page 285 in “References” for detailed information on
setting this feature.
Select Symbologies for Multiple Labels Ordering
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits From the alphanu-
meric characters In Appendix d, keypad representing
your desi
red Character(s). end by scanning the
enter/exit bar code again.
Make a mistake? Scan the CANCEL
bar code to
abort
and not save the entry string. You can then start
again at the beginning.
000000000000 = Random order
Multiple Labels Ordering by Code Length
Specifies the transmission ordering by code length, when Multiple Labels
per Frame is enabled.
DEFAULT
Multiple Labels Ordering = Disable
Transmit Increasing Length Order
Transmit Decreasing Length Order
To Next Page
Loading...
Need help?
General
Weight and Dimensions
