Datalogic PowerScan PBT9500 User Manual

Enter/Exit Programming Mode
228 PowerScan™ PD9530/PBT9500/PM9500
Bluetooth HID Variable PIN Code
Specifies the selection available for Static or Variable Pin Code, when Blue-
tooth HID profile is configured.
Some Bluetooth drivers on the Host (such as WIDCOMM and BlueSoleil 8)
require a Variable PIN Code. When attempting connection, the application
presents a window that includes a PIN Code which is to be input using the
PowerScan BT9500. Scan the bar code "Variable PIN Code" below, then use
the host computer’s Bluetooth manager to “Discover new devices” and select
"Datalogic Scanner." Use a text editor to see incoming data on the port des-
ignated by the computer's Bluetooth manager.
If you receive an error message, it may be necessary to disable
security on the device.
When you hear the beep and see the Green LED blinking indicating the
reader is waiting for an alphanumeric entry, enter the required variable PIN
Code by scanning the corresponding bar codes in
Appendix D, Keypad for
alphanumeric entry. Finish by scanning th
e Exit HID Va
riable PIN Code label.
$CBTHP00
Set Static Pin Code
DEFAULTDEFAULT
$CBTHP01
Set Variable Pin code
~
CANCEL
Make a mistake? Scan the CANCEL bar code to abort
and
not save the entry string. You can then start
again at the beginning.
Exit HID Variable PIN Code

Datalogic PowerScan PBT9500 Specifications

General

Type	Handheld bar code reader
Wavelength	680 nm
Sensor type	Laser
Scanner type	1D/2D
Tilt reading angle	0 - 360 °
Pitch reading angle	0 - 40 °
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	-
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, MaxiCode, Micro QR Code, QR Code
Battery life	10 h
Charging time	4 h
Battery capacity	2150 mAh
Power source type	Battery
Number of reads per charge	30000
Number of batteries supported	1
Wireless range	100 m
Operating frequency	2400 - 2480 MHz
Standard interfaces	USB, RS-232
Connectivity technology	Wired & Wireless
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Buzzer	Yes
Certification	IEC 62471 Class 1 LED
Product color	Black, Yellow
Protection features	Shock resistant, Water resistant
International Protection (IP) code	IP65
Cables included	RS-232

Weight and Dimensions

Depth	74 mm
Width	110 mm
Height	212 mm
Weight	380 g