Enter/Exit Programming Mode
252
PowerScan™ PD9530/PBT9500/PM9500
Set String ID
Sets the identifier of the predefined strings.
Set String ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by 6 digits from the Alphanumeric
characters in
Appendix D, Keypad
.
The ID characters must be represented by their
hexa-
decimal ASCII code; if the first 2 digits are 0, this fea-
ture is disabled. End by scanning the E
NTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL bar code to
abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Set String Header
Sets the header of the predefined strings.
Set String Header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by 32 digits from the Alphanumeric
characters in
Appendix D, Keypad
.
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the
ex
pected string of 16 characters are selected, scan the
ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort
and not save the entry string. You can then start
again at the beginning.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
