Datavideo TVS-2000A - Page 19

19
• Once in option 7, select YES to reset PAN, TILT and ZOOM values to factory defaults.
Step 3: Make sure the PTC-150 camera is positioned at a perfect horizontal line level. If the
camera is not positioned at the perfect horizontal line level, please open the main menu of the
PTC-150 camera and select 5: System  2: Set Motor  6: Tilt Offset ADJ. to fine tune the
camera’s vertical position to the perfect horizontal line level.
• Open the camera’s main menu and select the “System” option.
• Select “SET MOTOR.”
• Fine tune the camera position in the “TILT OFFSET ADJ.” option.