Table of Contents
DriveRack
™
Introduction
0.1 Defining the 240/241DriveRack™ ..................ii
0.2 Service Contact Info........................................iii
0.3 Warranty...........................................................iv
0.4 Quick Start........................................................v
Section 1 - Getting Started
1.1 Rear Panel Connections (240).........................2
1.2 Front Panel (240)............................................2
1.3 Rear Panel Connections (241).........................3
1.4 Front Panel (241)............................................4
Section 2 - Editing Functions
2.1 Basic Navigation Modes...................................6
2.2 Button Array Overview....................................6
2.3 Navigating the Pre-EQ Section........................8
2.4 Navigating the Post-EQ Section.......................8
2.5 Navigating the Crossover Sections..................9
2.6 Navigating the Delay Section ..........................9
2.7 Navigating the Dynamics Section..................10
2.8 Navigating the I/O Section............................10
2.9 Navigating the Utility Section........................10
Section 3 - Configuring the
DriveRack
3.1 Program Definition.........................................12
3.2 Navigating Factory Programs.........................12
3.3 Editing Factory Programs...............................13
3.4 Saving Factory Program Changes..................14
3.5 Creating a User Configuration.......................15
3.6 Saving Configuration Changes.......................18
Section 4 - Detailed Parameters
4.1 Input Routing..................................................20
4.2.1 Pre-Crossover EQ (31 Band Graphic)........20
4.2.2 Pre-Crossover EQ (9-Band Parametric)......20
4.4 Delay (Pre-Crossover)....................................21
4.5 Crossovers.......................................................22
4.6 Post-Crossover Parametric EQ.......................26
4.7 Compressor/Limiter (Dynamics)....................26
4.8 Speaker Alignment Delay ..............................28
4.9 Output.............................................................28
Section 5 - Utilities
5.1 Security Levels................................................30
5.2 Security Passwords.........................................31
5.3 Entering Security Password ...........................31
5.4 Program Change/Program list .......................32
5.5 Contrast Adjustment.......................................33
5.6 Power-up (Mutes/Saved) ...............................34
5.7 Load Stored.....................................................34
5.8 Switch Closure setup......................................35
Section 6 - DriveWare™ GUI
6.1 DriveWare Installation....................................38
System Requirements ...........................................38
Install.....................................................................38
Cable specs...........................................................40
Section 7 - Application Guide
7.1 2-Way FOH.....................................................42
7.2 2x4 Delay Cabinets ........................................43
7.3 L-C-R w/Sub....................................................44
7.4 Multi-Zone Controller.....................................45
7.5 Time Delay .....................................................46
7.6 Programmable Insert......................................47
7.7 Single Room Multi-Zone................................48
Appendix
A.1 Factory Reset..................................................50
A.2 Power up Quick Key Options......................50
A.3 Flash Downloads ...........................................51
A.4 Program List ...................................................51
A.5 Specifications..................................................52
A.6 Crossover Diagrams.......................................55
A.7 Gain Jumper Warning....................................56
A.8 Input and Output Section Diagrams ............57