• Select the Contrast adjustment by pressing the DATA wheel until the con-
trast percentage is selected. Once the contrast has been selected, proceed
to rotate the DATA wheel until the desired contrast has been established. To
exit, simply press the PROGRAM/CONFIG button. Contrast adjust ranges
from 0 to 100%.
Within the Utility menu, you have the option of changing the set up so that when the
DriveRack™ units are powered up, the output mutes will either power up all muted, or as they
were set prior to the unit shutting down. To change the PUP Mute setup, use the following
procedure.
• From Program mode, press the UTILITY button and use the PREV PG and
NEXT PG button to move to the page that appears as follows:
• Select the PUP mute adjustment by pressing the DATA wheel until the PUP
mute is selected. Once the PUP Mute has been selected, proceed to rotate
the DATA wheel until the desired mute setting (All, Saved or SyS Mute) is
selected. All= All outputs muted on powerup, Saved= Outputs mutes on pre-
vious power down and SYS Mute= the unit powers up all muted, but can be
unmuted by using a remote switch closure program as a “mute all” program.
To exit, simply press the PROGRAM/CONFIG button.
The Utility menu of the 240/241 DriveRack also offers the option of setting the Load stored fea-
ture to either on or off. The following explains the difference between Load On and Load OFF
settings.
LOAD On: After cycling the power (or power failure), the unit will automatically load a pro-
gram from the program table. No unstored edits will be saved.
LOAD OFF: After cycling the power (or power failure), the unit will automatically reload a con-
figuration exactly as it was prior to powering down. This includes any adjustments made to
any effect modules including: delays, EQs... etc.
5.7 Load Stored
To Next Page
Loading...
