Hardware
Note Make sure that all outputs are muted on the DriveRack™ prior to adding power to any
devices in the signal path (pre and post DriveRack™).
1. Connect the outputs from the mixer to the inputs of the DriveRack™.
2. Connect the outputs of the DriveRack™ and run to the selected speaker amplifier.
3. Making sure that all outputs are muted, apply power to the mixer and amplifiers.
Software
1. From Program mode, select factory program #22 (LR w/Delay) as a template.
2. Once the program has been chosen, press the PROGRAM/CONFIG button to load the pro-
gram.
3. Please see sections 3 and 4 (configuring and detailed parameter) for more information on
setting up and editing crossover points.
Notes: Each output of the crossover is a fully adjustable band pass filter. These filters will need
to be adjusted differently depending on signal.
Example:
Speech Only: Adjust the Low shelves to 120 Hz to eliminate thumping. Adjust
the high shelves to 10 kHz to eliminate preamp noise.
7.2- 2X4 Delay Cabinets
Application Guide
Section 7
DriveRack
™
43
DriveRack™ User Manual
FOH
Delay Cabs
240
or
241
To Next Page
Loading...
