Deep Sea Electronics Plc 5210

DSE Model 5210 Automatic Start Engine Management and Instrumentation System Operators Manual
8.3.3 PERKINS 2800 SERIES .............................................................................................36
8.3.4 SCANIA S6..................................................................................................................37
8.3.5 VOLVO TAD12............................................................................................................38
9 SPECIFICATION.............................................................................................39
10 COMMISSIONING .......................................................................................40
10.1.1 PRE-COMMISSIONING..............................................................................................40
11 FAULT FINDING..........................................................................................41
12 TYPICAL WIRING DIAGRAM......................................................................42
13 FACTORY DEFAULT CONFIGURATION ...................................................43
14 ICONS AND LCD IDENTIFICATION ...........................................................46
14.1 PUSH BUTTONS ...............................................................................................................46
14.2 STATUS / MEASUREMENT UNITS ..................................................................................46
14.3 ALARM INDICATIONS ......................................................................................................46
15 APPENDIX...................................................................................................47
15.1 ALTERNATIVE WIRING TOPOLOGIES...........................................................................47
15.1.1 3 PHASE, 3 WIRE.......................................................................................................47
15.1.2 1 PHASE, 2 WIRE.......................................................................................................47
15.1.3 2 PHASE, 3 WIRE ( 2 PHASE CENTRE TAP NEUTRAL) .........................................48
15.2 5210 IDMT TRIPPING CURVES (TYPICAL).....................................................................49
15.3 SENDER WIRING RECOMMENDATIONS .......................................................................50
15.3.1 EARTH RETURN SENDERS......................................................................................50
15.3.2 INSULATED RETURN SENDERS..............................................................................50
15.3.3 FUEL LEVEL SENDERS ............................................................................................51
15.4 J1939 CANBUS INTERFACE (OPTIONAL) .....................................................................52
15.4.1 EXAMPLE OF CONNECTING 5210 CONTROLLER TO ENGINE CANBUS. ...........52
15.5 5200 SERIES CONFIGURATION SOFTWARE AND P810 INTERFACE MODULE .......53
15.6 OUTPUT EXPANSION ......................................................................................................53
15.6.1 RELAY OUTPUT EXPANSION (157) .........................................................................53
15.6.2 LED OUTPUT EXPANSION (548)..............................................................................53
15.7 INPUT EXPANSION...........................................................................................................54
15.8 STANDBY GENERATING SET?.......................................................................................54
15.9 FULLY INTEGRATED AUTO MAINS FAILURE...............................................................54
5210 OPERATING MANUAL ISSUE 2 21/05/2003 AM 4