DSE Model 5210 Automatic Start Engine Management and Instrumentation System Operators Manual
15.7 INPUT EXPANSION
It is possible to increase the number of monitored inputs available by utilising a DSE 540/541 Protection
Expansion/Annunciator. Please refer to our Technical department for details.
15.8 STANDBY GENERATING SET?
The 5210 needs to be given a remote start signal to initiate an engine start. This can be supplied by a Mains/Utility
monitoring module to make the generating set start up automatically should the mains/utility supply fail. The 5210
module may be used in conjunction with DSE Automatic transfer switch controllers such as the model 500 (pictured
below), 705 or 530. These not only monitor the mains and issue a start command to the 5210, they also provide
control of the contactors or other changeover devices. Please refer to our Technical Support department for details.
Model 500
Deep Sea
Electronics plc
15.9 FULLY INTEGRATED AUTO MAINS FAILURE
The 5210 module can easily be upgraded with a 5220 controller. It has exactly the same mounting details and
uses exactly the same rear connectors. Upgrading takes seconds and instantly provides integral mains (utility)
monitoring and changeover functions in the same controller. Please refer to our website for details
(http://www.deepseaplc.com)
5210 OPERATING MANUAL ISSUE 2 21/05/2003 AM
54
To Next Page
Loading...
