DeLaval MPCII

Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
- Press F, 1, 1, and ↑.
Data item #
Data item # is shown for 0.5 seconds. The
transponder number is shown in the display.
- Press ↑
- The group number is shown.
- Finish by pressing F and ↑, or wait 30
seconds for time-out.
F13 – Calving date read/write
function
See function 1:3 in the system processor
Pressing F, 1, 3, and ↑ on the MPCII when
a cow is identified, shows the last calving
date.
Pressing ↑ after that shows next calculated
heat.
Example
- Press F, 1, 3, and ↑ on the MPCII display.
The last calving date (month.day) will be
displayed.
- Press ↑ on the MPCII.
or
The next heat (05.30) will be displayed. If
the cow is in heat, you can enter the new
date. Then the next heat date will be
displayed. If the cow is pregnant, latest
insemination date (05.09) is shown instead.
- Press ↑ on the MPCII to step forward to
next data. Finish by pressing F and ↑, or
wait 30 seconds for time-out.
F21 – Ration data read/write function
System
See function 2:1 in the system processor
The MPCII display shows daily feed ration
and available feed. It starts showing data for
feed No.1, then feed No.2, and so on. Step
61(94)