Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
New address of the MPCII:
If you now want to change the address,
press 6285 ↑ and write the new address.
F82 – Local cleaning mode
System and stand-alone
Pressing F, 8, 2, and ↑ on the MPCII forces
the MPCII to cleaning mode (emergency
function).
Note! Pulsation ratio always default 65/35
during cleaning mode.
Besides the ordinary set of functions in the
MPCII program, following four functions
(F83, F84, F85, and F86) are special for
Tandem.
F83 – Deactivate entrance photocell
Tandem System
This function will deactivate the photocell at
the main entrance.
The function can be used when a cow is not
used to the gates. It can also be used when
someone wants to walk through the gates,
and leave them open.
If F83 ↑ is pressed on an ordinary MPCII,
only the side where the MPCII is located,
will be deactivated. If F83 ↑ is pressed on
the special MPCII, both sides will be
deactivated. The adjoining display is shown
on the MPCII, when function F83 is used.
The main gate will not close after a cow
which has passed the photocell.
To activate the photocell again, just press
F83 ↑.
77(94)
To Next Page
Loading...
Need help?
General