DeLaval MPCII

Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
The value is a 7-days average, weighted
with milking interval.
Alarm level = "low yield level" x F39
F43 – Show last transponder read
only
System
See function 4:3 in the system processor
This function shows transponder number for
the cow that was last identified in the
walk-through ID. The function can be
entered on any MPCII on the same side as
the walk-through ID.
- Press F, 4, 3, and ↑
The transponder number is shown in the
display
- Finish by pressing F and ↑, or wait 30
seconds for time-out
F45 – Breeding status on MPCII
- Check the cow status on the MPCII by
pressing F 45 and ↑.
65(94)