Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
F325
Direct input of milk weight after take-off.
If milk flow indicators have been installed,
milk weight can be put into the MPCII (via
the numeric key pad) directly after take-off
and, as usual, stored after confirmed. This
feature is activated by setting this parameter
to YES (= 1). Manual:
+
F326
Milk yield presentation. The milk yield can
be shown expressed in kg or in pounds.
Former function F90, can only be changed
in standby mode.
F327
Pulsation/no pulsation during take-off. If
you want no pulsation during the take-off
phase, set this parameter to YES (= 1).
F328
Regulator block option. If regulator block
is used, set this parameter to YES (= 1).
F329
Milk meter type. No special software
needed depending on milk meter. 0 =
MM15, 1 = MM25, 2 = FI2, (3 = FI5 only
standalone).
F330
Regulator block option in standby. If you
want timer start of prerinse cleaning, set this
parameter to 1.
0 = activated for 90 minutes after milking.
F331
ID-mode. 0 = the row must be full before
milking can start. 1 = milking can start
before the whole parlour side is full.
F63 – Limits, timers, and options
F311
Display mode. Displays cow number, yield,
flow, time. 0 = Not displayed, 1 = displayed.
F321
Pre-milking time. Maximum pre-milking
duration. See time F in the diagram.
F322
72(94)
To Next Page
Loading...
Need help?
General