Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
F97 – BOOT version
This function shows the BOOT version
number. Read-only.
F98 – Application version
This function shows the application program
version of the active application.
F100 – Cow not ready milked
Only rotary
If a cow has not been milked completely
during one revolution, she may stay on the
Rotary for an additional revolution.
- Program F100 ↑ before the cow has
reached the position where milk yield will
be confirmed (see chapter General
description, position 3), and she will
continue to be milked during a second
round.
- If, however, F100 ↑ is pressed after
position 3, the cow will continue to be
milked during a second round. But, when
milk yield is confirmed at position 3 the
second time, milk yield from the first
round will be sent to function 3:7:3,
PROBLEM YIELDS (as Already milked)
and appear on the Problem List. Milk yield
from the second round will however be
stored normally.
F101 – Stop of platform
This function will stop the rotation of the
platform when the cow reaches the confirm
place, by sending a no cluster removal
signal from the special MPCII via a relay to
the drive control system. A function that can
be used for e.g. removal of a cows kick
protector before exit. It is deactivated with
F101 if the kick protector has been removed
before confirm place.
For connection see Installation menu.
82(94)
To Next Page
Loading...
Need help?
General