DeLaval MPCII User Manual

Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
F801 Activates LED 1 (don't milk)F801 Activates LED 1 (don't milk)
F802 Activates LED 2 (dump milk)F802 Activates LED 2 (dump milk)
F803 Activates LED 3 (treat cow)F803 Activates LED 3 (treat cow)
F804 Activates LED 4 (separate cow)F804 Activates LED 4 (separate cow)
F805 Activates LED 5 (feed alarm)F805 Activates LED 5 (feed alarm)
F806 Activates LED 6 (low yield)F806 Activates LED 6 (low yield)
F807 Activates LED 7 (milk flow)F807 Activates LED 7 (milk flow)
F808 Activates LED 8 (remind 1)F808 Activates LED 8 (remind 1)
F809 Activates LED 9 (remind 2)F809 Activates LED 9 (remind 2)
F810 Activates LED 10 (remind 3)F810 Activates LED 10 (remind 3)
F811 Activates LED 11 (remind 4)F811 Activates LED 11 (remind 4)
F812 Activates LED 12 (Forced high vac)F812 Activates LED 12 (Forced high vac)
F813 Activates LED 13 (manual)F813 Activates LED 13 (manual)
F814 Activates LED 14 (bus)F814 Activates LED 14 (bus)
F815 Activates all LEDsF815 Activates all LEDs
F831 Activates all segments on MPCIIF831 Activates all segments on MPCII
F850 Activates all LEDs one by oneF850 Activates all LEDs one by one
is deactivated 0.2 seconds after activation!is deactivated 0.2 seconds after activation!
** Do not forget to change F705, F706 to off if they are connected here.** Do not forget to change F705, F706 to off if they are connected here.
Test of milk meter:Test of milk meter:
F901 shows NN.nn NN = compensation value
(offset), normally 130 (25-231)
F901 shows NN.nn NN = compensation value
(offset), normally 130 (25-231)
nn = A/D value, empty cup 5 to
56, maximum loaded = 255
nn = A/D value, empty cup 5 to
56, maximum loaded = 255
F903 Opens the MM15's cup for 2 secondsF903 Opens the MM15's cup for 2 seconds
F910 ISO test MPCII is set to have high
vacuum and pulsating using
pulsating parameter of main
milking phase.
F910 ISO test MPCII is set to have high
vacuum and pulsating using
pulsating parameter of main
milking phase.
F911 ISO test at low flow (pre- and post milking phases)F911 ISO test at low flow (pre- and post milking phases)
F78 – Configuration check
System
This function shows the MPCII place
number.
See adjoining examples.
F79 – Show MPCII's address
System and stand-alone
Pressing F, 7, 9, and ↑ shows the MPCII's
node address for 3 seconds.
76(94)

DeLaval MPCII Specifications

General

Brand	DeLaval
Model	MPCII
Category	Controller
Language	English