Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
F443 – Calibration start
Only in parlour feeding
This function is used at calibration of the
dispenser.
- Press F443 ↑ and the dispenser starts
dispensing one portion.
The address of the MPCII is shown in the
display.
For a complete description of the calibration
procedure, see chapter Start-up.
F444 – Stop dispensing
Only in parlour feeding
This function is used to stop dispensing of
feed from the feed dispenser at this cow
place.
F449 – Calibration start one side
Only in parlour feeding
This function is used at calibration of all
dispensers on one parlour side. Instead of
using function F443 to start one dispenser,
it is possible to start dispensing one portion
from all dispensers on one side of the
parlour.
Stop feeding
To stop a single feed dispenser e.g. if the
cow at this place has been identified with a
wrong number, press F444↑ on the MPCII.
However, the feed dispensers will
automatically stop when the portion has
been entirely dispensed, or when the exit
gate has opened (milk yield confirmed).
F611 – Show time
System and stand-alone
Pressing F, 6, 1, 1, and ↑ shows the time
on the MPCII display.
- Finish by pressing F ↑, or wait for
time-out, 30 seconds
Note! If you open the processor memory,
86(94)
To Next Page
Loading...
Need help?
General