DeLaval MPCII User Manual

Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
milking session No.2, will start two days
from now, and last for two days.
The fourth status Separate the cow is set for
milking session No.1, will start three days
from now, and last for ever.
These parameters (F371, F372, F373, and
F374 respectively) can also be programmed
as short functions:
F, Remind Cow button, 1, and ENTER on
the MPCII sets "D not milk the cow" for the
present milking session and the same
session tomorrow and so on until reset.
F, Remind Cow button, 2, and ENTER on
the MPCII sets "Dump the milk" for the
present milking session and the same
session tomorrow and so on until reset.
F, Remind Cow button, 3, and ENTER on
the MPCII sets "Treat the cow" for the
present milking session and the same
session tomorrow and so on until reset.
1: –
This sign means that this cow can be
separated once, just this time.
This is a tmeoporary command, and it will (if
activated) separate the cow, irrespectively
of what has been programmed under 1, 2,
3, 4, WAIT, or DAYS.
By moving the cursor and pressing an
arbitrary numeral key, the "–" is changed to
"X", and the separation function is activated.
This function can be activated by pressing
F, Remind Cow button, 4, and ENTER on
the MPCII.
See next section, where the same settings
as on the processor above will be shown for
function F371 on the MPCII. The other three
functions, F372, F373, and F374 should be
set in a similar way.
84(94)

DeLaval MPCII Specifications

General

Brand	DeLaval
Model	MPCII
Category	Controller
Language	English