Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
New features in software
The new MPCII software has new features
and F-commands. Some old F-commands
have changed activity, as described
previously in this chapter.
The MPCII software is divided into one boot
program and one active application
program. It has the possibility to store one
extra application program as back-up. The
application program is basically the active
software and can be stored in two separate
pages, or slots. An EPROM is not used in
the MPCII.
No special MPCII software is required
depending on the type of milk meter. The
calibration routine with the MM15 is also
improved and easier.
Node address and milk meter calibration is
stored after software loading from the
ALPRO processor.
Changed/new F-commands
NOTE!: If the parlour is equipped with a mix
of MPC and MPCII note their node numbers
respectively. It is important to do separate
downloading of new software and
parameter setting.
MPC MPCIIMPC MPCII
Software Boot, Application program and 2 pages for application
programs
Software Boot, Application program and 2 pages for application
programs
FunctionsFunctions
F45 (from processor
6.15)
Shows breeding state, breeding attention and activity
attention.
F45 (from processor
6.15)
Shows breeding state, breeding attention and activity
attention.
F63 ↑ and 311 ↑ Cow 0=no, 1=yesF63 ↑ and 311 ↑ Cow 0=no, 1=yes
Yield 0=no, 1=yesYield 0=no, 1=yes
Flow 0=no, 1=yesFlow 0=no, 1=yes
Time 0=no, 1=yesTime 0=no, 1=yes
F62 ↑ 329 ↑ No special software required depending on milk meters.F62 ↑ 329 ↑ No special software required depending on milk meters.
Parameter settingParameter setting
0 = MM150 = MM15
1 = MM251 = MM25
88(94)
To Next Page
Loading...
Need help?
General