Dell EMC PowerProtect DD9900 - Installing the Front Bezel; Securing the Front of the Shelf; Installing the Bezel

Figure 58 Securing the front of the shelf
Installing the front bezel
Before you begin
CAUTION If the protective plastic strip is present on the front of the bezel, remove it before
placing the system into operation. Failure to remove the protective plastic strip will cause the
system to overheat.
About this task
Refer to Figure 59 on page 62 while performing this procedure.
Note:
If the rack is equipped with a door on the front, the shelf ships with an EMI shield
instead of a bezel.
Procedure
1. If present, remove the protective plastic strip from the front of the bezel.
2. Align the bezel with the enclosure.
3. Gently push the bezel into place on the cabinet until it latches.
4. If the bezel has a key lock, lock the bezel with the provided key.
Figure 59
Installing the bezel
CL5262
Install the Disk Shelves in the Rack
62 Dell EMC PowerProtect DD9900 System Installation Guide