Table 31 Export page settings
Item Description
Directory Path Enter a pathname for the export.
Add (+) button Click + to enter a system client or NFSv4 referral.
Pencil icon Modify a client or NFSv4 referral.
Delete (X) button Click X to delete a selected client or NFSv4 referral.
DD VTL protocol
The DD VTL Protocol settings section enables you to configure the DD Virtual Tape Library
settings. Click Yes to configure the DD VTL settings, or click No to skip DD VTL configuration.
VTL Protocol Library page
The Library page enables you to configure the DD VTL protocol settings for a library.
To configure these settings outside of the configuration wizard, select PROTOCOLS > VTL >
Virtual Tape Libraries > VTL Service > Libraries > More Tasks > Library > Create
Table 32 Library page settings
Item Description
Library Name Enter a name of from 1 to 32 alphanumeric characters.
Number of Drives Number of supported tape drives.
Drive Model Select the desired model from the drop-down list:
l
IBM-LTO-1
l
IBM-LTO-2
l
IBM-LTO-3
l
IBM-LTO-4
l
IBM-LTO-5 (default)
l
HP-LTO-3
l
HP-LTO-4
Number of Slots Enter the number of slots per library:
l
Up to 32,000 slots per library
l
Up to 64,000 slots per system
l
This should be equal to, or greater than, the number of drives.
Number of CAPs (Optional) Enter the number of cartridge access ports (CAPs):
l
Up to 100 CAPs per library
l
Up to 1000 CAPs per system
Changer Model Name Select the desired model from the drop-down list:
l
L180 (default)
l
RESTORER-L180
Configure System for Use
90 Dell EMC PowerProtect DD9900 System Installation Guide
To Next Page
Loading...
