NOTE: The color of the I/O connector cover may differ.
CAUTION: If you are permanently removing the sled, install a sled blank promptly. Operating the enclosure
without a blank, for an extended time can result in overheating or performance loss.
Next steps
1. Install the sled or the sled blank into the enclosure.
Installing the sled into enclosure
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 16.
CAUTION: To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
Steps
1. Remove the I/O connector cover from the I/O connector(s) and store for future use.
CAUTION: To protect the I/O connector pins, install the I/O connector cover every time a sled is removed
from the enclosure.
Figure 14. Removing the I/O connector cover from sled
NOTE: The color of the I/O connector cover may differ.
2. Press the blue release button on the sled to release the sled handle.
3. Holding the sled with both hands, align the sled with the compute sled-bay in the enclosure.
4. Slide the sled into the enclosure, until the sled handle is in the lock position.
5. Push the sled handle inwards so that it locks into place to secure the sled in the enclosure.
Installing and removing system components
19
To Next Page
Loading...
