Figure 29. Removing drive backplane
Next steps
1. Replace the drive backplane.
Installing drive backplane
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 16
2. Follow the procedure listed in Before working inside the sled.
Steps
1. Verify backplane connector pins are not bent and then connect the signal cable to the backplane.
2. Align the guide pins on the drive backplane with the sled.
3. Lower the drive backplane, until it is fully seated.
NOTE: To install the backplane, ensure the two pins on the backplane tab seat into the two slots on the system chassis.
Installing and removing system components 31
To Next Page
Loading...
