Figure 65. Installing the Jumbo PERC card
Next steps
1. Connect the cable on the Jumbo PERC card.
2. Follow the procedure listed in the After working inside your sled.
Optional Internal dual SD module
The IDSDM module combines the IDSDM features into a single module.
NOTE: The write-protect switch is on the IDSDM module.
Removing the IDSDM card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside the sled.
3. Remove the air shroud.
Steps
1. Locate the IDSDM card connector on the system board. To locate IDSDM connector, see the system board jumpers and
connectors section.
2. Using the Phillips #2 screwdriver, loosen the retention screw that connects the internal dual SD card (IDSDM) to the system
board.
CAUTION:
To prevent damage to the IDSDM card, you must not tilt the card while lifting it from the system
board.
3. Lift the release tab that secures the IDSDM to the system board.
4. Holding both ends of the IDSDM, lift the IDSDM out of the BOSS connector on the system board.
Installing and removing system components
67
To Next Page
Loading...
