Figure 84. Removing the system board
Next steps
1. Install the system board.
Installing the system board
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 16.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the
system.
Steps
1. Unpack the replacement system board assembly.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
NOTE: It is required to reactivate the licenses after the system board replacement.
2. Holding the system board by the edges, place the system board into the system.
3. Using the Phillips #2 screwdriver, secure the system board to the chassis with the screws.
86
Installing and removing system components
To Next Page
Loading...
