Figure 58. Removing the iDRAC
NOTE: The iDRAC module is not swappable with other MX series systems in the MX7000 enclosure.
NOTE: The procedure to remove vFlash card is similar to Removing the MIcroSD card.
Figure 59. Removing a vFlash card
Next steps
1. Install the iDRAC.
2. Follow the procedure listed in After working inside your sled on page 17.
Installing the iDRAC card
Prerequisites
CAUTION: To prevent damage to the iDRAC card, you must hold the card only by its edges.
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside the sled.
62
Installing and removing system components
To Next Page
Loading...
