Figure 74. Removing the Mezzanine card
Next steps
1. Install the Mezzanine card.
2. Follow the procedure listed in After working inside your sled on page 17.
Installing the Mezzanine card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside the sled.
NOTE: A dual-processor configuration is required to support the Mezzanine B1 card.
Steps
1. Align the connector on the Mezzanine card with the connector on the system board.
2. Place the Mezzanine card on the connector and press the blue touch point until it is firmly seated.
3. Use the Phillips #2 screwdriver, tighten the captive screws on the Mezzanine card.
76
Installing and removing system components
To Next Page
Loading...
