Interfaces | 375
Figure 19-1. show interfaces Command Example
Use the show ip interfaces brief command in the EXEC Privilege mode to view which interfaces are
enabled for Layer 3 data transmission. In Figure 19-2, GigabitEthernet interface 1/5 is in Layer 3 mode
since an IP address has been assigned to it and the interface’s status is operationally
up.
Figure 19-2. show ip interfaces brief Command Example (Partial)
Use the show interfaces configured command in the EXEC Privilege mode to view only configured
interfaces. In Figure 19-2, GigabitEthernet interface 1/5 is in Layer 3 mode since an IP address has been
assigned to it and the interface’s status is operationally
up.
To determine which physical interfaces are available, use the
show running-config command in EXEC
mode. This command displays all physical interfaces available on the line cards.
FTOS#show interfaces tengigabitethernet 1/0
TenGigabitEthernet 0/20 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:01:e8:a0:bf:ed
Current address is 00:01:e8:a0:bf:ed
Pluggable media present, QSFP type is 40GBASE-SR4
Wavelength is 850nm
QSFP receive power reading is -2.1304dBm
Interface index is 38863874
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:27:28
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:24:33
FTOS#show ip interface brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively down down
GigabitEthernet 1/1 unassigned NO Manual administratively down down
GigabitEthernet 1/2 unassigned YES Manual up up
GigabitEthernet 1/3 unassigned YES Manual up up
GigabitEthernet 1/4 unassigned YES Manual up up
GigabitEthernet 1/5 10.10.10.1 YES Manual up up
GigabitEthernet 1/6 unassigned NO Manual administratively down down
GigabitEthernet 1/7 unassigned NO Manual administratively down down
GigabitEthernet 1/8 unassigned NO Manual administratively down down
To Next Page
Loading...
