Dell Force10 Z9000 - Show an Ipv6 Interface

462 | IPv6 Routing
www.dell.com | support.dell.com
Show an IPv6 Interface
View the IPv6 configuration for a specific interface with the following command.
Figure 21-6 illustrates the
show ipv6 interface command output.
Command Syntax Command Mode Purpose
show ipv6 interface type {slot/
port}
EXEC Show the currently running configuration for the
specified interface.
Enter the keyword interface followed by the type of
interface and slot/port information:
• For all brief summary of IPv6 status and
configuration, enter the keyword brief.
• For all IPv6 configured interfaces, enter the
keyword configured.
• For a 10/100/1000 Ethernet interface, enter the
keyword
GigabitEthernet followed by the slot/
port information.
• For a Gigabit Ethernet interface, enter the
keyword
GigabitEthernet followed by the slot/
port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword TenGigabitEthernet followed by the
slot/port information.
• For a 40-Gigabit Ethernet interface, enter the
keyword fortyGigE followed by the slot/port
information.
• For a loopback interface, enter the keyword
loopback followed by the loopback number.
• For a linecard interface, enter the keyword
linecard followed by the slot number (Not
available on S4810).
• For a port-channel interface, enter the keyword
port-channel followed by the port-channel
number.
• For a VLAN interface, enter the keyword vlan
followed by the VLAN ID.