Interfaces | 415
Figure 19-34. Setting Auto-Negotiation Options
For details on the speed, duplex, and negotiation auto commands, see the Interfaces chapter of the FTOS
Command Reference Guide.
Adjust the keepalive timer
Use the keepalive command to change the time interval between keepalive messages on the interfaces.
The interface sends keepalive messages to itself to test network connectivity on the interface.
To change the default time interval between keepalive messages, use the following command:
To view the new setting, use the
show config command in the INTERFACE mode.
View Advanced Interface Information
Display Only Configured Interfaces
The following options have been implemented for show [ip | running-config] interfaces commands for (only)
linecard interfaces. When the
configured keyword is used, only interfaces that have non-default
configurations are displayed. Dummy linecard interfaces (created with the
linecard command) are treated
like any other physical interface.
Figure 19-35
lists the possible show commands that have the configured keyword available:
Command Syntax Command Mode Purpose
keepalive [seconds] INTERFACE Change the default interval between keepalive
messages.
FTOS(conf)# int gi 0/0
FTOS(conf-if)#neg auto
FTOS(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
FTOS(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
FTOS(conf-if-autoneg)#
To Next Page
Loading...
