460 | IPv6 Routing
www.dell.com | support.dell.com
Telnet with IPv6
IPv6 Telnet is supported on platforms c e s z
The Telnet client and server in FTOS support IPv6 connections. You can establish a Telnet session directly
to the router using an IPv6 Telnet client, or an IPv6 Telnet connection can be initiated from the router.
SNMP over IPv6
SNMP is supported on platforms c e s z
Simple Network Management Protocol (SNMP) can be configured over IPv6 transport so that an IPv6 host
can perform SNMP queries and receive SNMP notifications from a device running FTOS IPv6. The FTOS
SNMP-server commands for IPv6 have been extended to support IPv6. Refer to the
SNMP and SYSLOG
chapter in the
FTOS Command Line Reference Guide for more information regarding SNMP commands.
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Note: Telnet to link local addresses is supported on the S4810 and Z9000.
Command Syntax Command Mode Purpose
telnet
ipv6 address EXEC or
EXEC Privileged
Enter the IPv6 Address for the device.
ipv6 address : x:x:x:x::x
mask : prefix length 0-128
IPv6 addresses are normally written as eight groups of four hexadecimal digits, where
each group is separated by a colon (:). Omitting zeros is accepted as described in
Addressing earlier in this chapter.
To Next Page
Loading...
