Dell Force10 Z9000 - Configure Passive-Interface; Configure Stub Areas

Open Shortest Path First (OSPFv2 and OSPFv3) | 655
Use the no ipv6 router ospf process-id command syntax in the CONFIGURATION mode to disable OSPF.
Use the
clear ipv6 ospf process command syntax in the EXEC Privilege mode to reset the OSPFv3 process.
Configure stub areas
Configure Passive-Interface
Use the following command to suppress the interface’s participation on an OSPFv3 interface. This
command stops the router from sending updates on that interface.
To enable both receiving and sending routing updates, enter the
no passive-interface interface command.
When you configure a passive interface, the
show ipv6 ospf interface command adds the words “passive
interface” to indicate that hello packets are not transmitted on that interface.
Command Syntax Command Mode Usage
area area-id stub
[no-summary]
CONF-IPV6-ROUTER-OSPF Configure the area as a stub area. Use the
no-summary keywords to prevent transmission in
to the area of summary ASBR LSAs.
Area ID is a number or IP address assigned when
creating the Area.
The Area ID can be represented as a number
between 0 – 65536 if a dotted decimal format is
assigned, rather than an IP address.
Command Syntax Command Mode Usage
passive-interface
{type slot/port}
CONF-IPV6-ROUTER-OSPF Specify whether some or all some of the interfaces will be
passive.
Interface identifies the specific interface that will be
passive.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information
(e.g. passive-interface gi 2/1).
• For a port channel, enter the keyword port-channel
followed by a number from 1 to 255 for TeraScale and
ExaScale, 1 to 32 for EtherScale (e.g.
passive-interface
po 100)
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information ( e.g. passive-interface ten 2/3).
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094 (e.g. passive-interface
vlan 2222)
.
E-Series ExaScale platforms support 4094 VLANs with
FTOS version 8.2.1.0 and later. Earlier ExaScale
supports 2094 VLANS.