EasyManua.ls Logo

Dell Force10 Z9000 - Multicast Features; Enable IP Multicast; Implementation Information

Dell Force10 Z9000
984 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Multicast Features | 607
28
Multicast Features
Multicast Features are supported on platforms: e c s z
This chapter contains the following sections:
Enable IP Multicast on page 607
Multicast with ECMP on page 608
First Packet Forwarding for Lossless Multicast on page 609
Multicast Policies on page 610
Multicast Traceroute on page 617
FTOS supports the following multicast protocols:
PIM Sparse-Mode (PIM-SM) on page 673
PIM Source-Specific Mode (PIM-SSM) on page 683
Internet Group Management Protocol (IGMP) on page 361
Multicast Source Discovery Protocol (MSDP) on page 563
Implementation Information
Multicast is not supported on secondary IP addresses.
Enable IP Multicast
Enable IP Multicast is supported on platforms c e s z
Prior to enabling any multicast protocols, you must enable multicast routing.
Task Command Syntax Command Mode
Enable multicast routing. ip multicast-routing CONFIGURATION

Table of Contents

Other manuals for Dell Force10 Z9000

Related product manuals