Dell Force10 Z9000 - LACP Basic Configuration Example

Link Aggregation Control Protocol (LACP) | 477
Figure 22-10. Enabling Hitless LACP
LACP Basic Configuration Example
The screenshots in this section are based on the example topology shown in Figure 22-11. Two routers are
named ALPHA and BRAVO, and their hostname prompts reflect those names.
The sections are:
• Configuring a LAG on ALPHA on page 478
• Summary of the configuration on ALPHA on page 481
• Summary of the configuration on BRAVO on page 482
Figure 22-11. LACP Sample Topology
FTOS(conf)#redundancy protocol lacp
FTOS#show running-config redundancy
!
redundancy protocol lacp
FTOS#
FTOS#show running-config interface gigabitethernet 0/12
!
interface GigabitEthernet 0/12
no ip address
!
port-channel-protocol LACP
port-channel 200 mode active
no shutdown
Gig 2/31
Gig 3/21
Gig 2/32
Gig 3/22
Gig 2/33
Gig 3/23
Port Channel 10
ALPHA
BRAVO