Dell Force10 Z9000 - Exclude a Smaller Port Range; Exclude Duplicate Entries; Overlap Port Ranges

Interfaces | 399
• Overlap port ranges
• Commas
• Add ranges
Create a single-range
Figure 19-18. Creating a Single-Range Bulk Configuration
Create a multiple-range
Figure 19-19. Creating a Multiple-Range Prompt
Exclude duplicate entries
Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt:
Figure 19-20. Interface Range Prompt Excluding Duplicate Entries
Exclude a smaller port range
If interface range has multiple port ranges, the smaller port range is excluded from prompt:
Figure 19-21. Interface Range Prompt Excluding a Smaller Port Range
Overlap port ranges
If overlapping port ranges are specified, the port range is extended to the smallest start port number and
largest end port number:
Figure 19-22. Interface Range Prompt Including Overlapping Port Ranges
FTOS(config)# interface range gigabitethernet 5/1 - 23
FTOS(config-if-range-gi-5/1-23)# no shutdown
FTOS(conf)#interface range tengigabitethernet 3/0 , gigabitethernet 2/1 - 47 , vlan 1000
FTOS(conf-if-range-gi-2/1-47,so-5/0)#
FTOS(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
FTOS(conf-if-range-vl-1,vl-3)#
FTOS(conf)#interface range gigabitethernet 2/0 - 23 , gigabitethernet 2/0 - 23 , gigab 2/0 - 23
FTOS(conf-if-range-gi-2/0-23)#
FTOS(conf)#interface range gigabitethernet 2/0 - 23 , gigab 2/1 - 10
FTOS(conf-if-range-gi-2/0-23)#
FTOS(conf)#inte ra gi 2/1 - 11 , gi 2/1 - 23
FTOS(conf-if-range-gi-2/1-23)#