Dell Force10 Z9000 - Page 793

Security | 793
Enable and disabling privilege levels
Enter the enable or enable privilege-level command in the EXEC Privilege mode to set a user’s security
level. If you do not enter a privilege level, FTOS sets it to 15 by default.
To move to a lower privilege level, enter the command
disable followed by the level-number you wish to
set for the user in the EXEC Privilege mode. If you enter
disable without a level-number, your security
level is 1.
Reset a Z9000 password
Use the following procedure to reset a password on a Z9000 system.
Step Task
1 Connect to the Z9000 system via console.
2 Disconnect and reconnect the power cord on the system to cycle the power.
3 During system boot, press ESC when prompted to display the Grub Menu.
Version 2.00.1201. Copyright (C) 2009 American Megatrends, Inc.
EVALUATION COPY.
Press <DEL> or <F2> to enter setup.
Grub 1.99~rc1 (Dell Force10)
Built by root at bsdlab on Thu_Aug_18_06:51:21_UTC_2011
Z9000 Boot selector Label 3.0.1.1 NetBoot Label 0.0.0.0
4 During system boot, press ESC when prompted during the countdown to stop the
auto-boot process.
Entering Menu
Grub 1.99~rc1 (Dell Force10)
Built by root at bsdlab on Thu_Aug_18_06:51:21_UTC_2011
Z9000 Boot selector Label 3.0.1.1 NetBoot Label 0.0.0.0
+-----------------------------------------------------------------------
---+
|Force10 Boot |
| |
| |
| |
| |
| |
|
|
| |
| |
| |
| |
+-----------------------------------------------------------------------
---+
Use the ^ and v keys to select which entry is highlighted.
Press enter to boot the selected OS, 'e' to edit the commands
before booting or 'c' for a command-line.
5 Press C to access the Grub boot loader command line prompt.