Dell Force10 Z9000 - Page 955

Virtual Router Redundancy Protocol (VRRP) | 955
Figure 49-4. Command Example: virtual-address
Figure 49-5. Command Example Display:
show config for the Interface
Figure 49-6 shows the same VRRP group configured on multiple interfaces on different subnets.
2 Configure virtual IP addresses
for this VRID.
virtual-address ip-address1 [...ip-address12]
Range: up to 12 addresses
INTERFACE -VRID
Step Task Command Syntax Command Mode
FTOS(conf-if-gi-1/1-vrid-111)#virtual-address 10.10.10.1
FTOS(conf-if-gi-1/1-vrid-111)#virtual-address 10.10.10.2
FTOS(conf-if-gi-1/1-vrid-111)#virtual-address 10.10.10.3
FTOS(conf-if-gi-1/1-vrid-111)#
FTOS(conf-if-gi-1/1)#show conf
!
interface GigabitEthernet 1/1
ip address 10.10.10.1/24
!
vrrp-group 111
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
!
vrrp-group 222
no shutdown
FTOS(conf-if-gi-1/1)#
Note that the Primary IP address
and the Virtual IP addresses are
on the same subnet