Dell PowerConnect 6024 - Defining Out-Of-Band Default Gateways

124 Configuring System Information
www.dell.com | support.dell.com
The following is an example of the CLI commands:
Console(config)#logging oob/10.2.2.2 severity critical facility
local0 description syslog_server_1
Defining Out-of-Band Default Gateways
Use the OOB Default Gateway page to assign gateway devices. Packets are forwarded to the
default IP when frames are sent to a remote network. The configured IP address must belong to the
same IP address subnet of one of the IP interfaces. Removing the IP interface to which a default
gateway is connected, also removes the default gateway.
To open the
OOB Default Gateway page, click System → Out-of-Band Port → Default Gateway in
the tree view.
Figure 6-16. OOB Default Gateway
The OOB Default Gateway page contains the following parameter:
Default Gateway —Indicates the gateway device IP address.
Selecting a Out-of-Band Gateway Device
1 Open the OOB Default Gateway page.
Table 6-9. Out-of-Band Remote Log Server Settings CLI Commands
CLI Command Description
logging
oob/ip-
address
[port port ]
[severity
level ]
[facility f
acility ]
[description
text ]
Defines a new remote log server.