Dell PowerConnect 6024 - Viewing the OSPF Neighbor Table

368 Configuring Routing
www.dell.com | support.dell.com
The following is an example of the CLI commands:
Console> show ip ospf database
Viewing the OSPF Neighbor Table
The OSPF Neighbor Table describes all neighbors in the subject router's locality. To open the
Neighbor Table page, click Router → OSPF → Neighbors Table in the tree view.
Figure 8-18. Neighbors Table
IP Address — The IP Address this neighbor is using in its IP source address.
Network Mask — The neighboring interface network mask.
Neighbor Selection — Specifies which of the device’s neighbor information to display.
Neighbor’s Address — The neighbor IP address.
Priority — The neighbor priority.
Router ID — The neighbor Router ID.
State — The neighbor current state.
Displaying the Neighbors List
1 Open the OSPF Neighbors Table page.
2 In the Neighbor Selection column, click the option button of the neighbor for which you
want to view information
.
3 Click Show Neighbor’s Info .
The neighbor’s information displays at the bottom of the page.