Dell PowerConnect 6024 - Configuring IP Static Routes

334 Configuring Routing
www.dell.com | support.dell.com
Configuring IP Static Routes
Use the IP Static Route page to define static routes.
To open the IP Static Route page, click
Router → Global Routing Parameters → IP Static Route in
the tree view.
Figure 8-2. IP Static Route Page
Destination IP Address — Static route’s destination IP network.
Network Mask —The destination network mask for this route.
Prefix Length — The number of bits that comprise the destination IP address prefix. The length is
between 1-32 bits.
Next Hop — Indicates the next system address on the route.
Route Type — Specifies how remote routing is handled. The possible field values are:
Remote — Packet is forwarded.
Reject — Packet is dropped.
Local — Packet is sent to a local network.
Metric (1-255) — Number of hops to the destination network.
Adding Static IP Routes
NOTE: Only a directly connected router can be defined as a gateway.