Dell PowerConnect 6024 - Defining Out-Of-Band IP Interface Parameters

Configuring System Information 125
2 Define an IP address in the Default Gateway field.
3 Click Apply Changes .
The Out-of-Band Gateway device is defined, and the device is updated.
The following is an example of the CLI commands:
Console(config)# interface out-of-band-eth
Console(config-oob)# ip address 10.0.0.1 /8
Console(config-oob)# ip default-gateway 10.1.1.1
Defining Out-of-Band IP Interface Parameters
The OOB IP Interface Parameters page contains parameters for assigning Out-of-Band IP
addresses to interfaces.
To open the
OOB IP Interface Parameters page, click System → Out-of-Band Port → IP Interface
Parameters
in the tree view.
Table 6-10. Out-of-Band Default Gateway CLI Commands
CLI Command Description
ip default
gateway
ip-
address
Defines the Out-of-Band IP Gateway.