Dell PowerConnect 6024 - Device Default Settings; Enabling Remote Management

82 Configuring the Switch
www.dell.com | support.dell.com
The device is ready for configuration.
Device Default Settings
To return to device default settings use delete startup-config
command at the privileged mode prompt (#), and reboot the device.
Once device reloads – it is set with the default settings.
console>
console> enable
console# delete startup-config
Startup file was deleted
console# reload
This command will reset the whole system and disconnect your
current
session. Do you want to continue (y/n) [n] ?
y
**************************************************
***************** SYSTEM RESET *****************
**************************************************
.
.
.
.
Enabling Remote Management
1 Enter the enable command at the console to enter the Privileged EXEC screen mode as
follows:
console>enable
console#
2 Connect the management station (PC) to the device via one of the Ethernet ports, or
through a network connected to the device, using a CAT5 Cable.