78 Configuring the Switch
www.dell.com | support.dell.com
This section also describes accessing a switch for the first time with the default configuration and
definitions. If a previously entered configuration causes problems, the startup-configuration file—
which is the configuration of device when powered up—should be erased and device rebooted, see
"
Device Default Settings
."
Device Setup Requirements
The following components are required for the purpose of this example:
• PowerConnect 6024/6024F switch
• A workstation with the following components installed:
– Network adapter card
– ASCII terminal application (for example, Microsoft
®
Windows
®
HyperTerminal or
Procomm Plus Terminal)
– A browser application
• One Null Modem F2F cable.
• Straight or cross UTP (category 5) cable(s)
Initial Connection
1
Using the RS-232 port, connect the switch to the workstation.
2
Set the ASCII terminal with the following settings and select the appropriate COM port.
The sample screen uses the HyperTerminal.
To Next Page
Loading...
