Dell PowerConnect 6024 - Defining SNMP Notification Filters

214 Configuring System Information
www.dell.com | support.dell.com
Deleting Communities
1 Open the SNMPv1, 2 Community page.
2 Click Show All .
The
SNMPv1,2 Community Tables page opens.
3 Select a community and check the Remove check box.
4 Click Apply Changes .
The community entry is deleted, and the device is updated.
Configuring Communities Using CLI Commands
The following table summarizes equivalent CLI commands for defining fields displayed in the
SNMPv1, 2 Community
page.
The following is an example of CLI commands:
Console (config)# snmp-server community dell ro 10.1.1.1
Defining SNMP Notification Filters
The Notification Filter page permits filtering traps based on OIDs. Each OID is linked to a device
feature or a feature aspect. The
Notification Filter page also allows network managers to filter
notifications.
To open the
Notification Filter page , click System → SNMP → Notification Filters in the tree view.
Table 6-43. SNMP Community CLI Commands
CLI Command Description
snmp-server community
community [ro | rw |
su] [
ip-address ][view
view-name ][type
{router | oob}]
Sets up the community access string to permit
access to the SNMP protocol.
snmp-server
community-group
community group-name
[
ip-address ] [type
{router | oob}]
Sets up comunity access string to permit limited
access to the SNMP protocol based on group
access rights.
show snmp Displays the current SNMP device
configuration.