Dell PowerConnect 6024 - Defining IGMP Static Interface Groups

374 Configuring Routing
www.dell.com | support.dell.com
Defining IGMP Static Interface Groups
The IGMP Static Group Table enables static definition of IGMP groups on specific interfaces.
To open the
IGMP Static Group Table page, click Router → IP Multicast → IGMP Static Group
Ta ble
in the tree view.
Figure 8-21. IGMP Static Group Table
Interface — Specifies the port, VLAN, or LAG to which the specific multicast group is assigned.
IP Multicast Group Address — IP Multicast group address that is assigned to a interface.
New IP Multicast Group Address — The new IP Multicast group address assigned to an interface.
Assigning an Interface to a Multicast Group
1 Open the IGMP Static Group Table.
2 Select an interface in the Interface field.
3 Select an IP Address in the Multicast Group Address field, or define a new multicast group
address in the
New Multicast Group Address field .
4 Click Apply Changes .
Displaying the Static Interface Grouping Table
1 Open the IGMP Static Group Table .
2 Click Show All to display the Static Interface Grouping Table .